Buhler 2360, 2335, 2425, 2290, 2375 manual Tractor START-UP and Engine Operation, Engine Starting

SECTION 2 - OPERATION

TRACTOR START-UP AND ENGINE OPERATION

WARNING: AVOID POSSIBLE INJURY OR DEATH FROM A MACHINE RUNAWAY.

DO NOT START THE ENGINE BY SHORTING ACROSS STARTER TERMINALS. THE ENGINE CAN START AND THE MACHINE CAN MOVE WHEN THE STARTING SAFETY SWITCH IS BYPASSED.

CAUTION: PREVENT INADVERTENT TRACTOR OR IMPLEMENT MOVEMENT.

BE SURE THE HYDRAULIC CONTROL LEVERS ARE IN NEUTRAL AND THE 3-POINT HITCH IS SET TO THE LOWEST POSITION PRIOR TO STARTING THE TRACTOR WHEN ATTACHED TO AN IMPLEMENT.

THE TRACTOR CAN MOVE AS SOON AS THE ENGINE IS STARTED BY TURNING THE STEERING WHEEL, EVEN WITH THE PARK

BRAKE ENGAGED AND THE TRANSMISSION IN NEUTRAL. BE SURE ALL PERSONNEL ARE CLEAR OF THE TRACTOR BEFORE STARTING.

PRESTART INSPECTION

Do the following before starting the engine each day:

1.Check the engine oil level and adjust, if necessary.

2.Check the coolant level and adjust, if necessary.

3.Check and clean the radiator and grill for dirt and debris, if required.

4.Check the transmission and hydraulic oil tank levels and adjust, if necessary.

5.Inspect the condition of all belts, lights, switches, hoses, lines, fittings, seals, tires, nuts and bolts. Replace or tighten, if required.

6.Check the drawbar and 3-point hitch for wear, especially around metal-to-metal contact parts.

ENGINE STARTING

IMPORTANT: Protect the turbocharger during start-up by not opening the throttle or accelerating above 1000 RPM until the engine oil pressure gauge reads in the normal range. Avoid excessive engine speed during warm-up.

1.Fasten your seat belt.

2.Put the transmission in neutral.

3.On tractors equipped with a PTO, put the switch to the “OFF” position. A safety switch on PTO-equipped models permits engine starting only when the PTO is off.

4.Engage the park brake.

IMPORTANT: A safety switch in the park brake will not permit the tractor to start unless the park brake is engaged.

5.Check to be sure that the remote hydraulic levers are in the neutral position.

6.On tractors equipped with a 3-point hitch, make sure that the hitch controls are set to the lowest position.

7.Set the engine throttle to the lowest position.

8.Turn the ignition to “RUN” to activate the electrical accessories.

Observe the warning lamps to be sure they are functioning.

9.Turn the ignition to the “START” position to crank the engine, and release when the engine starts.

The switch has a starter protection feature built-in. If the switch is rotated to the start position, and then released to the run position, it will be necessary to rotate the switch to the stop position in order to make another attempt to start the tractor. This will prevent an accidental engagement of the engine starter motor when the engine is already running.

2-21