SECTION 2 - OPERATION

Position Four - “Field Use” - Rotating the switch to position four will shut off the front and rear roof-mounted warning lights and the rear fender-mounted taillights. The two sets of work lights, 1, located on the rear fenders will light. The single work lights, 2, located on the right and left front fenders will also light. All four headlights located above the front grille will also be lit.

All fender-mounted work lights can be adjusted up and down without loosening any hardware.

The background lights on the operator’s control panel behind the engine oil pressure and engine coolant temperature gauges, as well as the background light behind the fuel gauge and powershift gear display, if equipped, mounted on the right front cab post, will light. The small amber console light on the right front cab post under the fuel gauge and the background light in the performance monitor display window will also be lit.

NOTE: The multifunction stalk switch will not operate the high/low beam when the rotary light switch is in this position, even though the blue high beam light indicates high beam. All other functions of the multifunction stalk switch operate as if the rotary light switch was in the “OFF” position.

Position Five - “Field Use” - Rotating the switch to position five will do the same functions as in position four, but will also turn on the front and rear roof-mounted work lights, 1, if the tractor is equipped with this optional feature.

2

1

 

Figure 2-61

1

Figure 2-62

2-44

Page 102
Image 102
Buhler 2290, 2335, 2425, 2375, 2360 manual Operation