SECTION 2 - OPERATION

Combination Horn, Turn Signal, and Headlight Dimmer Switch Lever

The stalk-type multifunction switch, 1, operates the horn, turn signals, headlight flash and is used to select high or low beam.

Turn Signals - Move the stalk upward to indicate a right turn, or downward to indicate a left turn. The turn signal warning light on the warning light bar will flash when the signals are operated. The opposite warning light on the warning light bar will also light, but will remain steady. The turn signal must manually be returned to neutral after the turn is completed.

Headlights (High/Low Beams) - With the rotary select headlight switch in the roadway use position, the multifunction switch can be pulled toward the steering column to change the headlights from high to low beam and vice versa.

Headlight Flash - With the headlight rotary select switch in the off position, the multifunction switch can be pulled toward the steering column to flash the high or low beams of the grille- mounted headlights.

Horn - Press the button on the end of the multifunction switch to activate the horn.

Front Windshield Wiper Switch

The front windshield wiper switch, 1, is a three- position switch. Position one (when the bottom of the switch is flush with the dash) is the off position. Position two (when the switch is in the center rocker position) is low speed. Position three (when the top of the switch is pressed flush with the dash) is high speed.

NOTE: When the front windshield wiper switch is turned off, the wiper arm will always stop on the right side of the windshield.

1

Figure 2-18

1

Figure 2-19

2-13

Page 71
Image 71
Buhler 2425, 2335, 2290, 2375, 2360 manual Front Windshield Wiper Switch