Buhler 2290, 2335, 2425, 2375, 2360 manual 144

SECTION 2 - OPERATION

Turn the upper lift link end over end and mount it to the bottom hole in the upper link bracket.

NOTE: Turn end over end means that the hitch point of the link becomes the link point and vice versa.

Put the Category III bushings that are stored on the drawbar cage storage pin into the ball swivels, 1, at the upper and lower link hitch points.

Add or remove shims, 1, to ensure that the lower links do not contact the tires when they are free of the implement.

Reverse these steps to convert from a Category III to Category IV Narrow.

Be sure that the correct diameter pins are used in the hitch attaching points. Undersized pins may break and damage the implement or ball ends.

IMPORTANT: Use the correct diameter pins in the 3-point attaching links. Category III upper link pin size: 32 mm (1-1/4″) diameter. Lower link pin size: 37 mm (1-7/16″) diameter. Category IVN upper link pin size: 45 mm (1-3/4″) diameter. Lower link pin size: 50 mm (2″) diameter.

Figure 2-204

1

Figure 2-205

1

Figure 2-206

2-144