Buhler 2425, 2335, 2290, 2375, 2360 manual General Information

SECTION 1 - GENERAL INFORMATION

Buhler Versatile has a male connector, 1, that will plug into the three-pin auxiliary connector. It is available from your local Buhler Versatile dealer using part #86032122. This number will contain all parts necessary to install the male connector. Please contact your Buhler Versatile dealer for assistance in assembling the connector. A special tool is required to crimp the pins in the kit.

5.There is a secondary power source located on a four-pin bus bar behind the cowling that secures the fuel gauge. To access the four-pin bus bar, remove the four cap screws, 1, that secure the panel to the cab post.

NOTE: The power source pins are protected by a 10-amp and 3-amp fuse, respectively. The pins may not be suitable for use with an implement monitor (due to electrical load the monitor requires) and are intended for use with additional gauges installed by the operator. It is suggested that the 3-pin auxiliary connector be used to power the monitor.

1

Figure 1-46

1

Figure 1-47

1-31