Buhler 2290, 2335, 2425, 2375, 2360 manual Pressure Release Detent Adjustment, 129

SECTION 2 - OPERATION

The blue, green and tan in cab flow control knobs are in the right rear corner of the cab and function identically to the grey flow control.

PRESSURE RELEASE DETENT

ADJUSTMENT

The detent adjustment screw, 1, located on the rear of the valve, may be adjusted to vary the system pressure required to return each lever to the neutral position.

To adjust, loosen the jam nut and rotate the screw clockwise to increase the release detent pressure. A variable pressure flowmeter should be used to slowly raise the system pressure to accurately set each detent. The adjustment should be made by your authorized Buhler Versatile dealer.

NOTE: The factory pressure release detent setting is 15.0 bar (2175 PSI).

WARNING: ONLY ADJUST THE SCREW WHEN THE REMOTE CONTROL LEVERS ARE IN NEUTRAL AND THE TRACTOR IS SHUT OFF.

Figure 2-173

1

Figure 2-174

2-129