Buhler 2375, 2335, 2425, 2290, 2360 manual Engine Running Normal Operation

SECTION 2 - OPERATION

Engine Running - Normal Operation

There are six different modes the electronic monitor will be in depending on the position of the rotary select switch.

The upper half of the display will always show engine RPM no matter what position the rotary select switch is set at. The bottom half of the display will show a readout based on the position of the rotary select switch.

The readout will appear as follows for the six positions of the rotary select switch:

NOTE: See “Tractor Ground Speed” position for operation of the Electronic Instrument Control System at speeds greater than 20 km/h (12.5 MPH) when the rotary select switch is in positions other than “Tractor Ground Speed.”

Electrical System Voltage - The lower half of the display will show the condition of the battery voltage to the tenth of a volt and will also show the word “VOLTS” in the upper right corner of the lower display.

The readout value can be as much as one to one-and-a-half volts higher than with the engine off.

Figure 2-82

2-55