Buhler 2375, 2335, 2425, 2290, 2360 manual Setting the Transmission Output Shaft Gear Profile

SECTION 2 - OPERATION

8.Setting the Transmission Output Shaft Gear Profile

NOTE: Operation not applicable to tractors equipped with QSM 11 engines.

NOTE: This value is set when the machine is built. It does not require operator setup, and should never be changed. Instructions are provided here only in the event the value was inadvertently changed.

A.The upper portion of the monitor will flash “GEAR” and “SET,” with “SET UP” displayed. The lower portion of the display will show 30 or 60 depending on current programmed selection.

B.The output shaft gear profile is set depending on the transmission installed in the tractor:

12 x 4 Quad Shift III - 30

12 x 2 Powershift - 60

C.To place the correct value into the monitor, use the digit select switch. Move the switch to “UP” for 60, or “DOWN” for 30.

D.Push the acknowledge/reset button to enter the value into the monitor’s memory. The display will now go to “Setting the Engine Flywheel Ring Gear Profile.” If no further calibration is needed, turn the ignition switch to the “OFF” position. If further calibration is needed in other areas, select the area to be calibrated with the rotary select switch and proceed as detailed for that switch position.

Figure 2-102

2-70