Buhler 2290, 2335, 2425, 2375, 2360 manual Programming Units of Ground Speed Measurement

SECTION 2 - OPERATION

2.Programming Units of Ground Speed Measurement

A.With the upper portion of the monitor flashing “SEL” and “UNIT,” and displaying the word “SET UP,” select the unit of measurement desired (MPH or km/h) in the lower portion of the monitor. To do this, move the monitor select switch up or down.

B.Moving the digit select switch upward will make the MPH symbol become steady in the lower display. This means that the unit of measurement for tractor ground speed will be measured in miles per hour (MPH). The “km/h” will flash.

Moving the digit select switch downward will make the km/h symbol become steady. This means that the unit of measurement will be measured in kilometers per hour. The “MPH” will now flash.

C.After the unit of measurement has been selected, press the acknowledge/reset button once to enter the selection into the monitor’s memory.

NOTE: On tractors without the optional Tractor Performance Monitor, the display will now return to “Setting the Tire Radius.” On tractors with the optional Tractor Performance Monitor, the display will now return to step 1 of “Programming Units of Ground Speed Measurement.”

All possible calibration numbers for the ground speed position of the rotary select switch are now entered. If no further calibration is needed, turn the ignition to the “OFF” position. If further calibration is needed in other areas, select the area to be calibrated with the rotary select switch and proceed as detailed for that switch position.

Figure 2-94

2-64