Buhler 2290, 2335, 2425, 2375, 2360 manual Setting the Final Drive Ratio

SECTION 2 - OPERATION

7.Setting the Final Drive Ratio

NOTE: This value is set when the machine is built. It does not require operator setup, and should never be changed. Instructions are provided here only in the event the value was inadvertently changed.

A.The upper portion of the monitor will flash “FDR” and “SET,” with “SET UP” displayed when the calibration mode is first entered. The lower portion of the display will have the number displayed with the tenth digit (0.1) flashing.

B.The final drive ratio should be set at 25.8.

C.To place the correct value into the monitor, use the digit select switch to select the necessary numbers. The monitor will accept a value of 25.8.

D.Push the acknowledge/reset button to enter the value into the monitor’s memory. The display will now go to “Setting the Transmission Output Shaft Gear Profile.” If no further calibration is needed, turn the ignition switch to the “OFF” position. If further calibration is needed in other areas, select the area to be calibrated with the rotary select switch and proceed as detailed for that switch position.

Figure 2-101

2-69