Buhler 2335, 2425, 2290, 2375, 2360 manual Seat Adjustments

SECTION 2 - OPERATION

SEAT ADJUSTMENTS

NOTE: All adjustments should be made in the following order while sitting in the seat.

Adjust the seat using the following procedures:

NOTE: Turn the ignition switch to the “ACC” position to use the electric functions of the seat. DO NOT START THE ENGINE.

1. Height/Weight Adjustment

Raise -- Depress the top of the switch. Release when the desired height is obtained.

Lower -- Depress the bottom of the switch. Release when the desired height is achieved.

2. Backrest Angle Adjustment

Lift the lever and tilt the backrest to the desired position. Release the lever to lock the backrest in position.

NOTE: The backrest will tilt backward far enough to contact the rear window.

3. Fore/Aft Position Adjustment

Pull up on the lever and move the seat fore/aft through the 178 mm (7”) adjustment range to the desired position. Release the lever to lock the seat into position.

4. Fore/Aft Float

Pull up on the lever to allow the seat to float fore and aft 51 mm (2”). Push down on the lever to lock the seat into position.

5. Lateral Float

Pull up on the lever to allow the seat to float laterallt 51 mm (2”). Push down on the lever to lock the seat into position.

6.Storage tray

Pull out for access.

Figure 2-9

2-7