Buhler 2425, 2335, 2290, 2375, 2360 manual 148

SECTION 2 - OPERATION

9.If the measurement is not within specs, loosen the feedback potentiometer cover screws, 1.

10.Adjust the potentiometer by rotating the potentiometer cover plate tab, 2, CW to raise the hitch and CCW to lower the three-point hitch.

11.Tighten the adjustment screws and repeat the measuring procedures as detailed in steps 2 through 8.

12.A final quick check for the proper adjustment is to lift the three-point hitch in the automatic mode. Switch to the manual mode and depress in the raise position. The lift cylinder should extend approximately 6mm (1/4″) upward from the full automatic raise position.

IMPORTANT: In the automatic raise mode, the three-point hitch must automatically stop raising before the cylinders are fully extended.

2

1

Figure 2-214

2-148