Buhler 2375, 2335, 2425, 2290, 2360 manual Service Interval One Reset

SECTION 2 - OPERATION

3.Service Interval One Reset

Follow this procedure after the Electronic Instrument Control System has notified you that service interval one should be performed. Go through the scheduled service and then reset the accrued hours to zero.

A.The upper portion of the monitor will flash “PUSH,” “RE,” and “SET” along with displaying “SET UP.” The bottom portion will show the current hour meter reading accrued since the last service interval one reset.

B.Press the acknowledge/reset button once. The upper portion of the monitor will flash “RE” and “SET” along with displaying “SET UP.” The bottom portion of the display will show zero and has been reset. The monitor will now begin to recount the hours accumulated for the next service interval one.

If no further calibration is needed, turn the ignition to the “OFF” position. If further calibration is needed in other areas, select the area to be calibrated with the rotary select switch and proceed as detailed for that switch position.

Figure 2-95

Figure 2-96

2-65