Buhler 2375, 2335, 2425, 2290, 2360 manual Change the Ether Canister

SECTION 3 - LUBRICATION AND MAINTENANCE

AS REQUIRED

OPERATION 73

Change the Ether Canister

The cold start solenoid is located between the oil cooler/condenser and the radiator in the front nosepiece on the 2360 and 2425 tractors (shown in illustration). Access the oil cooler/condenser by unlatching the front grille of the tractor and swinging it out to the side.

To release the oil cooler/condenser assembly, pull the release handle to a flat position (90°) and pull the assembly toward you. It will swing the opposite direction of the grille. The cold start solenoid valve assembly, 1, is located on the left-hand wall of the tractor front nosepiece (your right as you look toward the radiator from the front of the tractor).

The cold start solenoid is located at the left hand rear hood support on the 2290, 2335 and 2375 tractors.

Remove the protective yellow cap, 2, or the empty ether canister from the top of the solenoid valve, but not the gasket. Lubricate the gasket with a light film of clean oil.

Remove the protective cap from the new ether canister.

2

1

Figure 3-123

3-74