Buhler 2425, 2335, 2290, 2375, 2360 manual Implement Status Switch, OPERATOR’S Controls, 103

SECTION 2 - OPERATION

Implement Status Switch

The implement status switch, 1, installed at a location on the 3-point hitch or on the drawbar implement, indicates to the console whether the implement is up (area accumulation off) or down (area accumulation on).

The console displays an “UP” message which should be synchronized with the implement position.

OPERATOR’S CONTROLS

The various functions of the touch-sensitive switches of the performance monitor are detailed in the following description. Read through this description completely before attempting to use the switches.

Each of the three touch-sensitive switches is multifunctional, performing one function in the OPERATE mode and another function in the SET UP mode.

The SET UP functions are indicated on the switch by symbols in the lower half and OEPRATE functions in the upper half.

NOTE: Whenever the ignition switch is turned from “OFF” to “RUN,” the Tractor Performance Monitor will automatically be in the OPERATE mode.

Each correct touch operation of any switch will be accompanied by a short beep from the alarm.

1

Figure 2-138

2-103