Buhler Troubleshooting Versatile Tractor Fault Codes: Solutions for Common Issues

SECTION 4 - TROUBLESHOOTING

TRANSMISSION

12x2 POWERSHIFT TRANSMISSION

The following list of error codes are shown on the gear display of the tractor if a fault is present. Listed with the error codes are their possible causes, effects, and the corrective measures required. Detailed trouble shooting information may be obtained by contacting a Buhler Versatile Dealer.

If the cause of the error code cannot be corrected by the measures suggested, contact your Buhler Versatile dealer.

NOTE: Repairs and adjustments to the powershift control system require special service tools and procedures to be performed by qualified technicians only; contact your Buhler Versatile dealer.

ERROR CODE CAUSE

PPInput power has dropped below 10.4 volts for more than 0.1 seconds.

I1, I2, I3, I4, I5	Internal control problem
TA	Output speed signal missing
	transmission shifts to neutral if
	clutch pedal depressed -- 1st
	engaged when clutch is released.
T2	Range selector switch combination
	invalid.
T3	Clutch pedal signal out of range or
	bottom pedal switch error.
T5	Engine load signal out of proper
	range.
T6	Input speed sensor circuit shorted
	or open.
T7	Output speed sensor circuit shorted
	or open.
S1, S2, S3, S4, S5, S6, Designated solenoid shorted or
S7, S8, S9	open.

TO CLEAR CODE

Low battery voltage Loose connection Bad ground

Bad power relay contacts Contact Buhler Versatile dealer. Contact Buhler Versatile dealer.

Contact Buhler Versatile dealer.

Contact Buhler Versatile dealer.

Contact Buhler Versatile dealer.

Contact Buhler Versatile dealer.

Contact Buhler Versatile dealer.

Contact Buhler Versatile dealer.

Contact Buhler Versatile dealer.

4-6