Buhler 2375, 2335, 2425, 2290, 2360 manual Storing the Tractor Preparation, Removal from Storage

SECTION 3 - LUBRICATION AND MAINTENANCE

AS REQUIRED

OPERATION 76

Storing the Tractor

NOTE: Storage refers to periods of approximately six months or greater.

Preparation:

Change the hydraulic oil.

Change the transmission oil.

Change the engine coolant.

Drain and flush the oil from the differentials and planetary housings. Fill with new oil.

Change the engine oil and filter.

Start the engine. While the engine is warming up, operate the transmission, hydraulic system, steering and differentials to distribute new lubricant to components. Warm engine to at least 70°C (160°F). Stop the engine.

Clean the tractor of all debris, dirt, and accumulated grease.

Drive the tractor to the storage location.

Relieve tension on the alternator, compressor, water pump, and fan belt.

Coat all exposed hydraulic cylinder shaft areas with grease or a rust preventive.

Fill the fuel tanks with fuel.

Storing:

Use plastic bags or tape to seal the following openings: muffler, fuel tank breather, air intake filter, and engine crankcase breather.

Touch up all scratches or chips.

Block up the tractor to remove weight from the tires.

Cover the tires if they will be exposed to heat or direct sunlight.

If the tractor is to be stored outside, cover it with a waterproof canvas or other protective material.

Remove the batteries from the tractor and store them in a cool, dry, weatherproof area. Do not store on a concrete floor.

Removal from Storage

Remove the protective covering from the tractor tires and seals from the air intake filter, muffler, fuel tank and engine crankcase breather.

Remove the blocks. Lower the tractor onto the tires.

Correct any leaks.

Inflate the tires to the recommended pressure.

Install fully charged batteries. Tighten the battery connections.

Tension the alternator, compressor, water pump and fan belt.

Check the fluid level of the engine crankcase, differentials, planetaries, transmission, hydraulic reservoir, brake cylinder reservoir and engine cooling system.

If the fuel filter is changed during or after storage, be sure that the filter, pump and lines are primed.

Drain sediment from the fuel tanks.

3-89