Buhler 2425, 2335, 2290, 2375, 2360 manual Change the Hydraulic Filter, Change the Transmission Filter

SECTION 3 - LUBRICATION AND MAINTENANCE

EVERY 500 HOURS

OPERATION 43

Change the Hydraulic Filter

The hydraulic filter is located under the front end of the tractor, directly below the engine, and is the filter on the right side of the frame (when viewing it from the operator’s seat).

The hydraulic filter, 1, is a spin-on, throwaway type and is removed by turning it counterclockwise. To install the new filter, lubricate the O ring on top of the new filter with clean hydraulic oil. Install the filter to the filter head, hand-tightening until the seal contacts the filter head. Tighten the filter an additional 1/2 to 3/4 turn.

NOTE: Some oil, approximately 1.9 L (2 qts.), may be lost when the filter is unscrewed from the filter head. Be sure to replenish the lost oil.

Start the engine and check for leaks at the filter.

NOTE: The transmission filter and hydraulic filter are the same part number.

1

Figure 3-66

OPERATION 44

Change the Transmission Filter

The transmission filter is located under the front end of the tractor directly below the engine, and is the filter on the left side of the frame (when viewing it from the operator’s seat).

The transmission filter, 1, is a spin-on, throwaway type and is removed by turning it counterclockwise. To install the new filter, lubricate the O ring on top of the new filter with clean transmission oil. Install the filter to the filter head, hand-tightening until the seal contacts the filter head. Tighten the filter an additional 1/2 to 3/4 turn.

NOTE: Some oil, approximately 0.95 L (1 qt.), may be lost when the filter is unscrewed from the filter head. Be sure to replenish the lost oil.

Start the engine and check for leaks at the filter.

NOTE: The transmission filter and hydraulic filter are the same part number.

1

Figure 3-67

3-47