Buhler 2360, 2335, 2425, 2290, 2375 manual Operation

SECTION 2 - OPERATION

PTO Speed - The lower half of the display will show the speed at which the PTO shaft is turning based on the engine RPM. The letters “PTO” will also be displayed in the lower right corner of the lower display.

The readout value shown for PTO speed is a factor of engine speed and is automatically calculated by the electronic monitor. There is no sensor on the tractor reading actual PTO output speed.

Tractor Ground Speed - The lower half of the display will show the true ground speed (if equipped with optional radar unit) and the radar symbol, or calculated ground speed (unit less radar option). The display will read km/h or MPH on the right side of the lower display based on the unit of measurement selected by the operator (see “Calibrating the Electronic Control Instrument System” later in this section for unit of measurement selection).

If the tractor is equipped with the optional radar unit, the radar symbol, 1, will also appear on the lower display indicating that the value shown is a true ground speed. If the radar symbol is not shown, then the ground speed is being calculated by the monitor based on a sensor signal on the transmission output shaft.

The value shown will be to the tenth of the unit of measurement, MPH or km/h, as selected by the operator.

Figure 2-83

Figure 2-84

1

Figure 2-85

2-56