Buhler 2290, 2335, 2425, 2375, 2360 manual PTO Operation, 119

SECTION 2 - OPERATION

4.Be sure that the PTO drive shaft halves have adequate overlap and will not separate when turning.

Pull drive halves apart until fully extended, just before they come completely apart. This is dimension A.

From dimension A, subtract 152.4mm (6″), establishing dimension B.

IMPORTANT: Never operate equipment with the driveline extended past dimension B.

Push drive halves together as far as possible. This is dimension C. Add 25.4mm (1″) to dimension C to establish dimension D.

IMPORTANT: Never operate equipment with the driveline collapsed past dimension D.

5.Be sure that all shields are in place and in good condition. They must fully shield the driveline.

6.Ensure that the PTO master shield, 1, is in position.

DANGER: NEVER REMOVE OR ALTER THE PTO MASTER SHIELD AT ANY TIME TO ASSIST IN ATTACHING ANY TYPE OF IMPLEMENT.

PTO Operation

1.Stop the engine and park the tractor. Connect the drawbar to the implement hitch. Turning the engine off releases the PTO brake, allowing the stub shaft to be hand turned for spline alignment. Be sure the drive shafts are straight for easier connection.

2.Attach the implement drive shaft to the tractor output shaft. Check for adequate telescope action and for clearance to the surrounding frame. The drawbar clevis, 1, can be flipped over to provide additional clearance for the PTO drive shaft.

DIM “D” EQUALS

DIM “C” + 25.4MM (1 in.)

Figure 2-156

1

Figure 2-157

1

Figure 2-158

2-119