Appendix J Troubleshooting
J.10.9 Diagnostics Center Problems
J.10.9 Diagnostics Center Problems
The Diagnostics Center provides different diagnostics operations at the following different network elements levels.
•Network Diagnostics
–Retrieve the current sync status and alarm status of all the nodes in the network.
–Support the network/node health statistics and manageability checks. At the network level, only the node manageability check results are supported.
•Node Diagnostics
–Retrieve current sync status, node alarm status, IP address, and several other node attributes.
–Retrieve the sync status of all the cards in the node.
–Request a node resync.
–Request VSI partition data and also perform VSI consistency checks on the node.
–Support node health statistics such as SNMP success counts and FTP/TFTP success/failure counts.
–Perform node manageability checks such as IP reachability and SNMP community string checks.
•Card Diagnostics
–Retrieve
–Retrieve card CPU usage on cards that support this functionality
–Retrieve the memory pool usage information on cards that support this functionality
–Retrieve the memory buffer pool usage Information on cards that support this functionality
–Retrieve
–Retrieve information about all lines and paths that are in loopback on the card
–Retrieve information about currently running BERT tests on the card
–Retrieve information about currently running IMA link tests
•Port Diagnostics
–Retrieve the
–Perform loopback
–Perform start/stop/modify BERT
–Retrieve the results and/or current status of the BERT
–Monitor the scheduled grooming results
–Configure the
–Retrieve the
•Line Diagnostics
–Retrieve the
–Perform loopback
–Perform start/stop/modify BERT
–Retrieve the results and/or current status of the BERT
|
| Cisco Transport Manager Release 6.0 User Guide |
|
|
|
|
|
| |||
|
|
|
|
| |
|
|
|
|
