- 19 -
(Read/Write) or is only able to view (Read
Only).
As a factory default, admin has Read/Write
access and guest has Read Only access.
There can only be one Read/Write user and up
to 5 Read Only users.
show loginsession
Displays all login session information
username <username> {p asswd |
nopasswd}
Allows the user to set passwords or change
passwords needed to login
A prompt will appear after the com m and is
entered requesting the old password. In the
absence of an old password leave the a rea
blank. The operator must press enter to
execute the command.
The system then prompts the user for a new
password then a prompt to confirm the new
password. If the new password and the
confirmed password match a message will be
displayed.
The user password should not be more than
eight characters in length.
copy running-config startup-config
[filename]
This will save passwords and all other
changes to the device.
If you do not save config, all configurations will
be lost when a power cycle is performed on the
switch or when t he switch is reset.
3.5.4 Quick Start up IP Address
To view the network parameters the operator can access the device by the following three methods.
• Simple Network Management Protocol - SNMP
• Telnet
• Web Browser
Table 2-4. Quick Start up IP Address
Command Details
show ip interface Displays the Network Configurations
IP Address - IP Address of the interface
Default IP is 192.168.2.1
Subnet Mask - IP Subnet Mask for the
interface. Default is 255.255.255.0
Default Gateway - The default Gateway for this
interface
Default value is 0.0.0.0
Burned in MAC Address - The Burned in MAC
Address used for inband co nnectivity
Network Configurations Protocol Curren t -
Indicates which network pr otocol is being
used. Default is none