- 840 -
Refresh - Refresh the page with the latest Tunnel entries.
11.4.11 Managing Loopbacks
11.4.11.1 Configuring Loopbacks Configuration Page
Loopback interfaces can be created, configured and remove d on this page.
Configurable Data
Loopback - Select list of currently configure d loopba ck interfaces. Create is also a valid choice if the
maximum number of loopback interfaces has not been created.
Loopback ID - When 'Create' is cho sen from the Loopback selector this list of available loopback ID's
becomes visible.
Protocol - Select IPv4 or IPv6 to configure the corresponding attributes on the loopback interface.
IPv6 Mode - Enable IPv6 on this interface using the IPv6 address. This optio n is only configurable
prior to specifying an explicit IPv6 address.
IPv6 Address - Select list of configured IPv6 addresses for the selected Loopback interface. Add is
also a valid choice if the maximum number of addresses has not been configured.
IPv6 Address - When 'Add' is chosen from the IPv6 Address sele ctor this IPv6 address input field
becomes visible. Address must be enter ed in the format prefix/length.
The user also has the option to specify the 64-bit extended unique identifier (EUI-64).
IPv4 Address - The primary IPv4 address for this interface in dotted de cimal notation.
IPv4 Subnet Mask - The primary IPv4 subnet mask for this interface in dotted decimal notation.
Secondary Address - Select list of configure d IPv4 secondary ad dresses for the sele cted Loopback
interface. Add Secondary is also a valid choice if the maximum number of secondary addresses ha s
not been configured. A primary address must be configured before secondary addresses can be
added.
Secondary IP Address - The seconda ry ip address for this interface in dotted decimal n otation. This
input field is visible only when 'Add Secondary' is selected.
Secondary Subnet Mask - The second ary subnet ma sk for this inte rface in dotted de cimal notation.
This input field is visible only when 'Add Secon dary' is selected.
Command Buttons