- 198 -
7.3.13.12 set sflow poller index
The user can go to the CLI I nterface Configuration Mode to configure a new sFlow poller instance, use the
sflow poller <index> interface configuration command. Use the no sflow poller return to default setting.
Syntax
sflow poller <index>
no sflow poller
Default Setting
None
Command Mode
Interface Config
7.3.14 Service Port Commands
7.3.14.1 show serviceport
This command displ ay s s ervice port configuration information.
Syntax
show serviceport
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface Status: Indicates whether the interface is up or down.
IP Address: The IP address of the interface. The factory default value is 0.0.0.0.
Subnet Mask: The IP subnet mask for this interface. The factory default value is 0.0.0.0.
Default Gateway :The default gateway for this IP interface. The factory default value is 0.0.0.0.
IPv6 Administrative Mode: Whether enabled or disabled. Defaul t value is enabled.
IPv6 Address/Length: The IPv6 address and length. Default is Link Local format.
IPv6 Default Router: T he default gateway address on the service port. The factory default value is
an unspecified address.
ServPort Configured Protocol Curren t: Indicates what network protocol was used on thela s t, or
current power-up cycle, if any.
Burned In MAC Address: The burned in MAC address used for in -band connectivity.