- 200 -
Syntax
serviceport ip <ipaddr> <n etmask>
<ipaddr> - The user manu ally configures IP address for this switch.
<netmask> - The user manually configures Subnet Mask for this switch.
Default Setting
None
Command Mode
Global Config
7.3.14.4 serviceport protocol
This command specifie s the network management po rt configuration protocol. If you modify this value,
the change is effective immediately. If you use the bootp parameter, the switch periodically sends
requests to a BootP server until a response is received. If you use the dhcp parameter, the switch
periodically sends request s to a DHCP server until a response is received. If you use the none parameter,
you must configure the network information for the switch manually.
Syntax
serviceport protocol {none | bootp | dhcp | dhcp6}
none - Configure the network informatio n for the switch manually.
bootp - Periodically sends requests to a BootP server until a response is received.
dhcp - Periodically sends requests to a DHCP server until a response is re ceived.
dhcp6 - Periodically sends requests to a DHCPv6 server until a re sponse is received.
Default Setting
None
Command Mode
Global Config
7.3.14.5 serviceport ipv6 enable
Use this command to enable IPv6 operat ion on the service port.