- 620 -
System Up time - The time in days, hours a nd minutes since the last switch reboot.
Current SNTP Syncronized Time - Displays currently synch ronized SNTP time in UTC. If time is not
syncronised, it displays "Not Syncroni zed."
MIBs Supported - The list of MIBs supported by the management agent running on this switch.
Command Buttons
Submit - Update the switch with the values on the screen. If you want the swit ch to retain the new
values across a power cycle you must perform a save .
11.2.3.2 Configuring Service Port Page
You use this panel to specify the parameters needed to communicate with the switch over a network
using the service port.
Selection Criteria
Service Port Configuration Protocol Current - Choose what the switch should do following
power-up: transmit a Bootp request, transmit a DHCP request, or d o nothing (None). The factory
default is None.
You cannot make this choi ce for both the network co nfiguration protocol and the service p ort. You will
only be given the choices for Bootp or DHCP here if the network configuration protocol is configured
to None.
Protocol - Choose IPv4 or IPv6 protocol.
IPv6 Mode - Enable/Disable IPv6.
IPv6 Prefix - Choose a IPv6 prefix.
DHCP6 Client - Selects if the DHCP6 Client is enabled or disabled.
You cannot make this choice fo r both the In-Band M gmt and the Out-of-B and Mgmt. You wi ll only be
given the choices for Enable here if the In -Band Mgmt is configured to Disable.
Configurable Data
IP Address - The IP address of the interface. The factory default value is 0.0.0.0
Subnet Mask - The IP subnet mask for the interface. The factory d efault value is 0.0.0.0
Default Gateway - The default gateway for the IP interface. The factory default value is 0.0.0.0
IPv6 Gateway - The default gateway for the IPv6 interface. The factory default value is None