- 43 -
Source: This port is a monitoring port.
PC Mbr: This port is a member of a port-channel (LAG).
Dest: This port is a probe port.
Admin Mode: Selects the Port control administration state. The port must be enabled in order for it to
be allowed into the network. It may be enabled or disa bled. The factory default is enabled.
Physical Mode: Selects the desire d port speed and duplex mode. If auto-negoti ation support is
selected, then the duplex mode and sp eed will be set from the auto-negotiation process. Note that the
port's maximum capability (full duplex 100M) will be advertised. Otherwise, this obje ct will determine
the port's duplex mode and transmission rate. The factory default is Auto.
Physical Status: Indicates the port speed and duplex mode.
Link Status: Indicates whether the Link is up or down.
Link Trap: This object determines whether to send a trap wh en link status changes. The factory
default is enabled.
LACP Mode: Displays whether LA CP is enabled or disabled on this port.
Flow Control Mode: Displays flow control mode. The possible values are:
None: This port is disabled flow control.
802.3X: This port is enabled flow control.
PFC: This port is enable Priority Flow control.
Capabilities Status: Displays interface capabilities.
7.2.1.2 show interface counters
This command displays a summary of statistics for a specific interface or all interfaces.
Syntax
show interface counters {<slot/port> | all}
<slot/port> - is the desired interface num ber.
all - This command display s statisti cs information for all interfaces.
Default Setting
None
Command Mode
Privileged Exec
Display Message
The display parameters when the argument is '<slot/port>' are as follows:
Packets Received Without Error: The total number of packets (including broadcast packet s and
multicast packets) received by the processor.
Packets Received With Error: The nu mber of inbound packets that contained errors preventing
them from being deliverable to a higher-layer protocol.