- 276 -
7.10.2 Configuration Commands
7.10.2.1 sntp broadcast client poll-interval
This command will set the poll interval for SNTP broadcast clients in seconds as a power of two where
<poll-interval> can be a value from 6 to 10.
Syntax
sntp broadcast client poll-interval <6-10>
no sntp broadcast client poll-interval
<6-10> - The range is 6 to 10.
no - This command will reset the poll interval for SNTP broadcast client back to its default value.
Default Setting
6
Command Mode
Global Config
7.10.2.2 sntp client mode
This command will enable Simple Network Time Protocol (SNTP) client mode and optionally setting the
mode to either broadcast, multicast, or unicast.
Syntax
sntp client mode [broadcast | unica st | multicast]
no sntp client mode
no - This command will disable Simple Network Time Protocol (SNTP) client mode.
i
The SNTP IPv4 multicast address is 224. 0.1.1.
The SNTP IPv6 multicast address is ff05::101.
IPv6 address doesn’t support broadcast mode.
Default Setting
None
Command Mode
Global Config