- 966 -
Multicast Group IPv6 - Select the IPv6 multicast group address for whi ch data i s to be displa yed. If
no group membership re ports have bee n received on the MLD Proxy interface you will not b e able to
make this selection, and none of the non-configura ble data will be displayed.
Non-Configurable Da ta
Slot/Port - Displays the interface on which MLD proxy is enabled.
Source IPv6 - This parameter shows source addresses which are members of this multicast address.
Expiry Time - This parameter shows expiry time inte rval against each source address which is a
member of this multicast group. This is the amount of time after which the specified source entry is
aged out.
Last Reporter - The IPv6 address of the sou rce of the last membership rep ort received for the IPv6
Multicast group address on the selected interface.
Up Time - Displays the up time since the entry was created in cache table.
State - The state of the host entry. A Host can be in one of the state. Non-member state - does not
belong to the group on the interface. Delaying member state - host belongs to the group on th e
interface and report timer runnin g. The report timer is used to send out the repo rts. Idle member state
- host belongs to the group on the interface and no report timer running.
Filter Mode - The group filter mode (Include/Exclude/None) for the specified gro up on the MLD Proxy
interface.
11.9.2 Managing PIM-DM
11.9.2.1 Configuring PIM-DM Global Configuration Page
Selection Criteria
Admin Mode - Select enable or disabl e from the pulldown menu to set the administrative status of
PIM-DM in the router to active or inactive. The default is disabled.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.