- 540 -

9.8.2 Configuration Commands

9.8.2.1 ipv6 mld-proxy

This command enables ML D-Proxy on the router. To enable MLD-Proxy on the router, you must enable
multicast forwarding. Also, make sure that there are no other multicast routing protocols enabled n the
router.
Syntax
ipv6 mld-proxy
no ipv6 mld-proxy
no - This command disab les the MLD-Proxy on the router.
Default Setting
Disabled
Command Mode
Interface Config

9.8.2.2 ipv6 mld-proxy reset-status

This command reset s reset the host interface status param eters of the MLD-Proxy router. T his command
is only valid when you enable MLD-Pr oxy on the interface.
Syntax
ipv6 mld-proxy reset-status
Default Setting
None
Command Mode
Interface Config

9.8.2.3 ipv6 mld-proxy unsolicit-rprt-interval

This command sets the un solicited report interval for the MLD-Proxy router. This command is only valid
when you enable MLD-Pr oxy on the interface. The value of <inter val> is 1-260 seconds.
Syntax
ipv6 mld-proxy unsolicit-rprt-interval <1-260>