- 493 -
9. IP Multicast Commands
9.1 Distance Vector Multicast Routing Protocol (DVMRP) Commands
This section provides a detailed explanation of the DVMRP commands. The commands are divided into
the following different groups:
Show commands are used to display device settings, statistics and other information. Configuration
commands are used to conf igure features and options of the switch. For every configuration command
there is a show command that will display the configuration setting.
9.1.1 Show Commands
9.1.1.1 show ip dvmrp
This command displays the system-wide information for DVMRP.
Syntax
show ip dvmrp
Default Setting
None
Command Mode
Privileged Exec
User EXEC
Admin Mode This field indicates wh ether DVMRP is enabled or disabled. This is a configu red value.
Display Message
Admin Mode: Enable or disable DVMRP function.
Version: This field indicates the versio n of DVMRP being used.
Total Number of Routes: This field indi cates the number of routes in the DVMRP routing table.
Reachable Routes: This field indicates the number of entries in the routing table with
non-infinitemetrics. The followin g fields are displayed for each interface.
Slot/Port: Valid slot and port number separated by forward slashes.
Interface Mode: This field indicates the mode of this interface. Possible values are Enabled and
Disabled.
State: This field indicates the current state of DVMRP on this interface. Possible values are
Operational or Non-Operational.