- 199 -
7.3.14.2 show serviceport ndp
This command displays IPv6 Neigh bor entries.
Syntax
show serviceport ndp
Default Setting
None
Command Mode
Privileged Exec
Display Message
IPv6 Address: Specifies the IPv6 address of neighbor or interface.
MAC Address: Specifies MAC add ress associated with an interface.
isRr:. Specifies router flag.
Neighbor State:
Incmp - Address resolution is being performed on the entry. A neighbor solicitation message ha s
been sent to the solicited-node multicast address of the target, but the corresponding neighbo r
advertisement message has not yet been received.
Reach - Positive confirmation was received within the l ast Reachable Time milliseconds that the
forward path to the neigh bor was functioning properly. While in REACH state, the device takes no
special action as packets are se nt.
Stale - More than ReachableTime millise conds have e lapsed sin ce the last positive confirm ation
was received that the forward path was functioning properly. Whil e in STALE state, the device
takes no action until a packet is sent.
Delay - More than ReachableTime milliseco nds have elapsed since the last positive confi rmation
was received that the forward path was functioning properly. A packet was sent within the last
DELAY_FIRST_PROBE_TIME seconds. If no reachabi lity confirmation is received within
DELAY_FIRST_PROBE_TIME seconds of ent ering the DELAY state, send a neighbo r
solicitation message and change the state to PROBE.
Probe - A reachability confirmation is actively sought by resending neighbor solicitation
messages every RetransTimer milliseconds until a reachability confirmation is received.
Age Updated: Time since the address was confirmed to be rea ch able.
7.3.14.3 serviceport ip
This command sets the IP address, the netmask and the gateway of the network management
port.