- 510 -
Queries Received: The number of valid MLD queries received by the router.
Queries Sent: The number of valid MLD que ries sent by the router.
Reports Receiv ed: The number of valid MLD reports received by the router.
Reports Sent: The number of valid MLD reports sent by the router.
Leaves Received: The number of valid MLD leaves received by the router.
Leaves Sent: The number of valid MLD leaves sent by the router.
Bad Checksum MLD Packets: The number of bad checksum MLD packets received by the router.
Malformed MLD Packets: The number of malformed MLD packets re ceived by the router.
9.3.2 Configuration Commands
9.3.2.1 ipv6 mld query-interval
Use this command to set the MLD route r’s qu ery interval for the interface. The query-i nterval is the
amount of time between the general que ries sent when the router is the querier on that interface. The
range for <query-interval> i s 1 to 3600 seconds.
Syntax
ipv6 mld query-interval <1-3600>
no ipv6 mld query-interval
no – Use this command to reset the MLD query interval to the default value for that interface.
Default Setting
125
Command Mode
Interface Config
9.3.2.2 ipv6 mld query-max-response-time
Use this command to set the MLD que rier’s maximum response time for the interface and thi s value is
used in assigning the maximum response time in the query messages that are sent on that interface. The
range for <query-max-responsetime> is 0 to 65535 millise con ds.
Syntax
ipv6 mld query-max-response-time <1-65535>
no ipv6 mld query-max-response-time
no - This command resets the MLD query max response time for the interface to the default value.