Fortinet 548B 10.4 OSPFv3 Commands

- 566 -
10.3.2.21 ipv6 neighbors static
The user can add/delete a static neighbor into neighbor cache table.
Syntax
ipv6 neighbors static <ipv6-address> <mac-address>
no ipv6 neighbors static <ipv6-ad dress>
<ipv6-address> - Enter the IPv6 Address.
<mac-address> - Enter th e MAC Address.
no – This command sets I P v6 neighbor configuration to default values.
Default Setting
None
Command Mode
Global Config
10.4 OSPFv3 Commands
This section describ es the commands you use to configure OSPFv3 , which is a link-state routing protocol
that you use to route traffic within a network.
10.4.1 Show Commands
10.4.1.1 show ipv6 ospf
This command displays information relevant to the OSPF router.
Syntax
show ipv6 ospf
Default Setting
None
Command Mode
Privileged Exec
Display Messages
NOTE: Some of the information below displays only if you enable OSPF and conf igure certain
features.