Polycom 3725-76302-001O manual Configure Signaling, To enter license activation key codes

Local Cluster Configuration

To enter license activation key codes

1Go to Admin > Local Cluster > Licenses.

2In the Activation key field for the first (or only) server, enter the activation key code that was generated for that server’s serial number.

Caution: Activation Keys Linked to the Server Serial Number

An activation key is linked to a specific server’s serial number. Each Activation Key field is labeled with a serial number. For a two-server cluster, make sure that the activation key code you enter for each server is the correct one for that server’s serial number.

3If you have a two-server cluster, in the Activation key field for the second server, enter the activation key code that was generated for that server’s serial number.

4Click Update.

A dialog box informs you that the licenses have been updated.

5Click OK.

See also:

Licenses on page 70

Configure Signaling

To configure signaling

1Go to Admin > Local Cluster > Signaling Settings.

2To make the system accessible via H.323 calls: a Select Enable H.323 signaling.

b Leave the default port numbers (1720 for H.225, 1719 for RAS) unless you have a good reason for changing them.

cSelect H.323 multicast to support gatekeeper discovery messages from endpoints.

dTo turn on H.235 authentication, select Enable H.323 device authentication.

Device authentication credentials must be added on the Inbound Authentication tab of the Device Authentication page. Click the Device authentication settings link to go directly there.

3To make the system accessible via SIP calls: a Select Enable SIP signaling.

b To enable pass-through of ANAT signaling (RFC 4091 and RFC 4092) in the Session Description Protocol (SDP) for the purpose of negotiating IP version in a dual-stack (IPv4 + IPv6) environment, select Enable ANAT support.

c If the system’s security settings permit unencrypted SIP connections, optionally set Unencrypted SIP port to TCP or UDP/TCP.

You must have the Administrator role to change security settings. See Security Settings on page 50.

Polycom, Inc. 83