Polycom 3725-76302-001O manual Routing Configuration Dialog Box, IPv6address%eth0

Local Cluster Configuration

Field	Description
Management DSCP	The Differentiated Services Code Point value (0 - 63) to put in the DS field of
	IP packet headers on outbound packets associated with management traffic
	(including communications to other clusters.
	The DSCP value is used to classify packets for quality of service (QoS)
	purposes. If you’re not sure what value to use, leave the default of 0.
Default IPv6 gateway	The IPv6 gateway’s address and the interface used to access it, generally
	eth0, specified as:
	<IPv6_address>%eth0
Default IPv4 gateway	If management and signaling traffic are on separate networks, select which of
	the two networks’ gateway servers is the default.
	Your choice depends on your network configuration and routing. Typically,
	unless all the endpoints, MCUs, and other devices that communicate with the
	system are on the same subnet, you’d select the signaling network.

See also:

Local Cluster Configuration on page 63

Local Cluster Configuration Procedures on page 81

Routing Configuration Dialog Box

In the Network page’s action list, the Routing Configuration command opens the Routing Configuration dialog box, where you can add or delete network routing rules (IPv4, IPv6, or both, depending on the System IP type setting on the Network page). The Show raw routing configuration button lets you view the operating system’s underlying routing configuration.

In a split network configuration, routing rules are necessary for proper routing of network traffic. In a combined network configuration, the operating system’s underlying routing configuration is likely sufficient unless you need a special rule or rules for your particular network. If you aren’t sure, consult the appropriate IT staff or network administrator for your organization.

Note: Route Configuration Applies to Current Network Settings

You can only configure route settings that are valid for the currently applied settings in Admin > Local Cluster > Network Settings. If you need to change the network settings and routing configuration, make and apply the network settings changes first. Keep this in mind if you receive an error when attempting to change the routing configuration.

The following table describes the fields in the Routing Configuration dialog box. If System IP type is set to IPv4 + IPv6, the dialog box contains two essentially identical sections, one for each IP type. Each section contains the input fields listed below, a table showing the defined routing rules, and buttons for adding and deleting routes.

Polycom, Inc. 68