Polycom 3725-76302-001O manual Default Dial Plan and Suggestions for Modifications, Callersipuri

Call Server Configuration

Field	Description
Caller site	Select a site in order to set the four caller site variables:
	•	CALLER_SITE_NAME
	•	CALLER_SITE_DIGITS
	•	CALLER_SITE_COUNTRY_CODE
	• CALLER_SITE_AREA_CODE
	These variables can’t be set directly and are display only.
CALLER_H323ID	Test caller’s H323-ID or blank.
CALLER_E164	Test caller’s H.323 E.164 alias or blank.
CALLER_TEL_URI	Test caller’s SIP tel URI or blank.
CALLER_SIP_URI	Test caller’s SIP sip URI or blank.
Dial string	Enter a dial string to test. Then click Test. For SIP, the dial string should
	always specify the schema prefix (sip or sips). For example:
		sips:rbruce@10.47.7.9
Test route output	Displays the results of applying each rule (including its preliminary, if any) to
	the dial string.
	For instance, testing the dial string example shown above against the default
	dial plan might result in the following:
		#1:SipAlias[sips:rbruce@10.47.7.9] is not registered. H323-ID[rbruce]
		is not registered.
		#2:The room [rbruce] does not exist.
		#3:No entry queue is found.
		#4:Domain [10.47.7.9] is not within our administration.
		#5:The call was accepted by this dial rule.
Final result	Displays the final outcome of the dial rule processing. The final outcome for
	the example above would be:
		Transformed dial string is [sips:rbruce@10.47.7.9]. The call was
		accepted by dial rule #5.

See also:

Dial Rules on page 239

Add Dial Rule Dialog Box on page 244

Edit Dial Rule Dialog Box on page 248

Preliminary/Postliminary Scripting on page 251

The Default Dial Plan and Suggestions for Modifications

The Polycom RealPresence DMA system is configured by default with a generic dial plan that covers many common scenarios and may prove adequate for your needs. It’s described in the table below.

Polycom, Inc. 241