Polycom 7000 manual To remove a cluster from the supercluster

Superclustering

8Log back in and verify that the Supercluster Status pane of the Dashboard shows the correct number of servers and clusters, and there are no warnings.

9Go to Network > RealPresence DMAs, verify that the status of each RealPresence DMA cluster is Superclustered, and reassign territory responsibilities as needed.

To remove a cluster from the supercluster

Note: Remove a cluster only while its servers are operational

If possible, remove a cluster only while its server or servers are on line. If you must remove a cluster while one or both servers are off line, be aware that an offline server may be in an inconsistent state when it’s brought back on line. If this occurs, the system attempts to auto-correct the situation. But if the auto-correction steps fail, the only supported procedure for fixing a server in this state is to re-install it from media.

1Make sure that there are no calls on the cluster, and that all of its MCUs are out of service. See MCU Procedures.

2Reassign all of the cluster’s territory responsibilities to a different cluster.

3Go to Network > RealPresence DMAs. In the list, select the cluster you want to remove.

4In the Actions list, select Remove from Supercluster.

5When asked to confirm that you want to remove the cluster, click Yes.

The selected cluster is removed from the supercluster. A dialog informs you when the process is complete. If the cluster you removed is the one you’re logged in to, it logs you out and restarts.

6Click OK to log out immediately, or simply wait.

Note: Restart your browser

You may need to restart your browser or flush your browser cache in order to log back into the system.

7Log into the system you removed and verify on the Supercluster Status pane of the Dashboard that the system is no longer superclustered.

See also:

About Superclustering

DMAs

Join Supercluster Dialog

Polycom, Inc. 232