Polycom 7000 manual Add Subnet Dialog, Field

Site Topology

Field	Description
IP Address	The IP address of the subnet.
	You can define overlapping subnets; larger subnets can contain smaller ones.
	When the system determines which subnet a given IP address belongs to, it
	chooses the subnet with the longest IP address match. For example:
	subnet1 = 10.0.0.0/8
	subnet2 = 10.33.24.0/24
	The IP address 10.33.24.70 belongs to subnet2. The IP address
	10.22.23.70 belongs to subnet1.
Subnet Mask Length	The CIDR (Classless Inter-Domain Routing) prefix size value (the number of
	leading 1 bits in the routing prefix mask). This value, together with the IP
	Address, defines the subnet.
	For IPv4, a value of 24 is equivalent to specifying a dotted-quad subnet mask
	of 255.255.255.0. A value of 16 is equivalent to specifying a subnet mask of
	255.255.0.0.
	You can use subnet mask lengths of up to 32 bits; a 32-bit subnet mask allows
	you to specify a single device.
Max Total Bandwidth (Mbps)	The total bandwidth limit for voice and video calls.
Max Per-Call Bit Rate (kbps)	The per-call bit rate limit for voice and video calls.
	When you specify both the bandwidth and bit rate limits, the dialog shows you
	how many calls at that bit rate the specified bandwidth limit supports. The
	value of the Bit rate to bandwidth conversion factor setting on the Call
	Server Settings page is used in this calculation.

See also:

About Site Topology

Sites

Add Subnet Dialog

Edit Subnet Dialog

Site Topology Configuration Procedures

Add Subnet Dialog

Lets you add subnets to the site you’re adding or editing.

Note: Subnets and sites

You can assign a subnet to only one site.

The following table describes the fields in the dialog.

Field

Name

IP address

Description

The name of the subnet. Required and must be unique.

The IP address of the subnet.

Polycom, Inc. 294