Toshiba CTX28 manual Installing the CTX100 Cabinet, Remove Cabinet Covers, Removal

Strata CTX100-S/CTX100 Installation

Installing the CTX100 Cabinet

Installing the CTX100 Cabinet

Step 1: Remove Cabinet Covers

WARNING! Ensure the power supply AC plug is not

plugged into the AC outlet.

1. Loosen the screws from the front cover to remove it.

2. Loosen the four screws from the top cover and slide it off.

3. Loosen the four screws from each side cover and pull the covers forward to remove them.

	6074
Figure 3-3	Cabinet Cover
	Removal

Step 10: Remove the Back Cover from the Cabinet(s)

1.Remove and save the two screws from the back of the Base Unit.

2.Slide the metal cover about a half inch to the right (it will drop down and forward) to remove it.

3.If you are installing an Expansion Cabinet, remove one screw from the back of the Expansion Cabinet. Slide the metal cover to the right to remove it.

Note The figure below show the position of the screws. Back covers should be removed before the Base and Expansion cabinets are attached to each other.

EXPANSIONBASE

Remove 1 screw

5933

Figure 3-4 Base and Expansion Cabinet Back Covers

3-6 Strata CTX I&M 06/04