ISDN Interfaces

RBSU/RBSS Interface Units

Step 3: Install the REBS

Note The REBS provides a basic part of the RBSU/RBSS circuit functionality; therefore, it must always be installed on the RBSU (see Figure 7-13).

1.Align the two connectors carefully while observing the “UP” arrows on the REBS.

2.Plug the REBS onto the RBSU.

Step 4: Install the RBSS

Note If one or two additional BRI-NT circuits are required, install the RBSS (see Figure 7-13).

1.Align the four connectors carefully while observing the “UP” arrows on the REBS.

2.Plug the RBSS onto the RBSU.

Step 5: Install the R40S

Note If ISDN PS-1 backup power for TE devices is required, install the R40S (optional PCB) (see Figure 7-13).

1.Align the two connectors carefully while observing the “UP” arrows on the R40S.

2.Plug the R40S onto the RBSU.

RBSU

Optional RBSS1A

UP

REBS (always install)

UP

UP

UP

Two-circuit Subassembly

2761

UP

UP

Optional PS-1 Power Supply

R40S1A-CM V.1

R40S

Figure 7-13 Location of RBSU Plug-on PCBs

7-18

Strata CTX I&M 06/04

Page 284
Image 284
Toshiba CTX28 manual Install the Rebs, Install the Rbss, Install the R40S