Toshiba CTX28 manual Remote Cabinet Installation Instructions, Remove/Replace Remote Cabinet Cover

Strata CTX670 Installation

Remote Expansion Cabinet Unit

Remote Cabinet Installation Instructions

All instructions apply to both the Base Cabinet and the Remote Expansion Cabinet except where specifically noted.

1.Install cabinets according to the instructions given at the beginning of this chapter. Pay particular attention to wiring and grounding instructions given for Remote Expansion Cabinets.

2.If installing a standalone Remote Expansion Cabinet, or the first in a stack, set the “BASE/ EXP” switch to “BASE” in accordance with Figure 4-3.

3.Cabinets in which RRCU cards are installed must be modified to protect the routing of the cables through the cabinet.

•Attach the plastic guide to the bracket provided with the RRCU1A card. See Figure 4-40.

•Attach the bracket to the inner wall of the cabinet.

4.Install the RRCU Card

•Select correct jumper options (see Figure 4-41). On the Master side, both option plugs connect the center pin to the upper pin (M1, M2). On the Slave side, both option plugs connect the center pin to the lower pin (S1, S2).

•Remove the protective rubber cap from the fiber connector on the ROMS1A daughter board. See Figure 4-42.

5.Install a BCTC1A top cover on the topmost cabinet (see Figure 4-39).

Top View

Place lid over screws and slide it to the right.

5030

Figure 4-39 Remove/Replace Remote Cabinet Cover

4-56 Strata CTX I&M 06/04