Toshiba CTX28 Take Off Front and Back Covers, Take Off Base of Cabinet, Attach Cabinet to Rack

Rack Mount Cabinets

Step 2: Install First Cabinet

Step 2A: Take Off Front and Back Covers

1.Unscrew the two screws holding the front cover to the unit and slide the cover off.

2.Unscrew the four screws holding the back cover to the unit and take the cover off.

Step 2B: Take Off Base of Cabinet

Important! If two people are installing these cabinets, you can skip this step and proceed to item 3 under Step 2C.

Unscrew the two screws holding the base of the cabinet secure and slide the cabinet back off the base (shown below).

6971

Screws

Step 2C: Attach Cabinet to Rack

In order to line up the first cabinet installed in the rack, you must position the bottom-most hole on the flange with the top of two holes on the rack (marked Start on Figure 5-3).

The holes on the rack form a pattern of three-holes. A single hole 5/8” above the previous hole, followed by two holes (1/2” apart) for a total space of 1-1/8”.

Important! If you do not start the cabinet installation in one of the holes marked Start in Figure 5-3on page 5-7, the next cabinet will not match with the holes on the rack.

1.Attach the base of the cabinet to the rack with two screws on each flange (shown below). Refer to the rack manufacturer’s documentation for screw size. Toshiba does not provide rack screws.

19"

Start

(see Fig. 4-3)		Start
		(see Fig. 4-3)
	6973
2 Screws per Flange		Mounting Pillar of 19" Rack

2. Put the cabinet on the base and slide the cabinet back so that it completely covers the base.

5-6 Strata CTX I&M 06/04