Toshiba CTX28 manual REMU2A Tie Line Unit

PCB Installation

REMU2A – Tie Line Unit

Note The “GND” position is used to connect PEMU circuits back-to-back on premises only, 1000 feet maximum (E&M lead wires must be crossed).

5.Insert the PEMU (component side facing right) into the appropriate slot and apply firm, even pressure to ensure proper mating of connectors.)

6.After installing, gently pull the PEMU outward. If the connectors are properly mated, a slight resistance is felt.

Table 6-16 REMU2A and REMU1A Controls, Indicators, and Connectors

Control/Indicator/	Type of Component	Description
Connector
Tie trunk circuits 1~4	Red LED	Lights to indicate that Tie line is in operation.
(CD102, 202, 302, and 402)
E&M Tie trunk connector
circuits 1~4 (J101, 201, 301,	Modular connector	Interface connector for E&M Tie line circuit.
and 401)
Pad switch SW101 (circuit 1)
Pad switch SW201 (circuit 2)	2-position slide switch	Enables -3 dB signal level drop for line circuit.
Pad switch SW301 (circuit 3)
Pad switch SW401 (circuit 4)
TYP1/TYP2 jumper plugs
P102/104
TYP1/TYP2 jumper plugs
P202/204	3-terminal jumper	Enables line circuit to be set for Type 1 or Type
		2 signaling.
TYP1/TYP2 jumper plugs
P302/304
TYP1/TYP2 jumper plugs
P402/404
2W/4W switch 102 (circuit 1)
2W/4W switch 202 (circuit 2)	2-position slide switch	Selects 2- or 4-wire configuration for E&M Tie
		line circuit.
2W/4W switch 302 (circuit 3)
2W/4W switch 402 (circuit 4)
TYP1,2/DC5 jumper plugs		For most countries, use the default position
P105, P205, P305, P405	3-terminal jumper	(TYP1,2). In the U.K. and Japan, place the
(REMU2A only)		jumper plug on DC5.
Mu Law/A Law jumper plug		Do not move the jumper plug which is in the
		default for the U.S. and Canada. For countries
P2	3-terminal jumper
		requiring A Law, place the jumper plug
(REMU2A only)
		(provided in the PCB box) on the A Law side.

PCB Installation

Strata CTX I&M 06/04 6-33