Toshiba CTX28 manual Install BIPU-M2A, Connect BIPU-M2A to LAN or VPN Server

IP Telephony and QSIG Over IP

Pre-installation Guidelines

Step 2: Install BIPU-M2A

1.Make sure the BIPS1A is installed onto the BIPU-M2A PCB (see Figure 9-2).

2.Install the BIPU-M2A into one of the following slots:

•CTX100 Base and Expansion Cabinet slots (1~8, 8 or 16 IPTs per slot per Program 100)

•CTX670 Base Cabinet slots (1~8, 8 or 16 IPTs per slot per Program 100)

•CTX670 Expansion Cabinet slots (1~6, 8 or 16 IPTs per slot per Program 100)

3.Follow the procedure in “Worksheet 7 – System Power Factor Check” on page 2-42to check the cabinet power factor.

4.Power up the system.

5.Program the CTX per the instructions in the Strata CTX Programming Manual, refer to the chapter titled “IP Telephone Programming” and “Appendix A – “Applications, Tips, and Tricks.”

Connect BIPU-M2A to LAN or VPN Server

1.Plug one end of a straight-through CAT5/5E/6 LAN cable into the RJ45 Ethernet port on the BIPU-M2A PCB in the CTX. (See Figure 9-2.)

2.Plug the other end of the BIPU-M2A CAT5/5E/6 LAN cable into a LAN or server jack (see Figures 9-8and 9-9.)

Note The BIPU-M2A or Q1A-switch cables are straight-through cables.

RS232 Maintenance Jack

Ethernet Port LEDs

RD

LINK

SD

RJ45 Ethernet Port

Heart Beat LED

Status/Alarm LEDs For engineering purposes only

Reset

				P601
							P2
	RD LINK
	SD
0211		PTC1111-01	YCL
	HB
			V.01
					P701
1 2 3 4						P702
5 6 7 8
						P704
					P703

BIPU-M2A or BIPU-Q1A

P705 P706

P708

P707

Factory

Installed

BIPS1A - /16

Backplane Connector

6632

Figure 9-2 BIPU-M2A or BIPU-Q1A PCB ZZ

9-6 Strata CTX I&M 06/04