Toshiba CTX28 manual CO Line PCBs Strata Net Over VoIP Interface Unit BIPU-Q1A, Interface Options

Strata CTX Configuration

Universal Slot PCBs

Table 2-9 CO Line PCBs

Strata Net Over VoIP Interface Unit (BIPU-Q1A)

Provides 16 IP QSIG channels	Interface Options: LAN, Virtual Private Network (VPN)
One 100Base-TX RJ45 port	Internet, VPN WAN, Intranet.
One RS-232 maintenance port
QSIG over IP standard protocol (ECMA-336)
Voice coding G.711/G.729A
Built-in Digital Signal Processor (DSP) (BIPS1A-16)
NAT compatible
Internet Protocol (IP) Interface Unit (BVPU)
Provides four VoIP Circuits as E&M Tie lines	Interface Options: LAN, Internet, WAN.
One 10Base-T port
One RS-232 maintenance port
H.323 standard for Voice over Internet Protocol
(VoIP)
Caller ID Interface Unit (RCIU2)
Provides four Caller ID circuits.	Interface Options:
With RCIS: eight circuits.	Provides Caller ID LCD display for analog loop or
	ground start lines with Caller ID. Requires: RCOU,
	RCOS, RGLU2, RGLU3 or PCOU. Not compatible with
	T1.
Caller ID Interface Subassembly (RCIS)	Same as RCIU2.
Attaches to the RCIU2.
Direct Inward Dialing Interface Unit (RDDU)
Provides four DID circuits.	Interface Options:
	DID analog lines.
Enhanced 911 CAMA Trunk Interface Unit (RMCU/RCMS)
E911 CAMA circuits. Provides up to four CAMA trunk	E911 analog CAMA trunks.
circuits. The RMCU/RCMS eliminates the need for
connection of adjunct terminal adapter equipment to
E911 CAMA trunks.
Requires one or two RCMS PCBs for two or four
CAMA lines respectively.
CAMA Trunk Subassembly (RCMS)	Same as RMCU.
RCMS attaches to RMCU. Provides two E911 CAMA
circuits.
Up to two RCMSs per RMCU for four CAMA lines
max. (One RCMS comes packaged with the RMCU.)
Ground/Loop Start Interface CO Line Interface Unit (RGLU2, RGLU3)
Provides four ground or loop start line circuits. Each	Interface Options:
can be individually set for ground or loop start	Analog loop or ground start analog lines.
operation.
ISDN S/T-type Basic Rate Interface Unit (RBSU)
Two ISDN BRI S/T point circuits (NT or TE). Each	Interface Options: Network and/or station side.
circuit is 2B+1D. (Host for the RBSS.)
Basic Rate Interface Subassembly (RBSS)	Interface Options: Station side only.
Attaches to RBSU. One RBSS subassembly per
RBSU.
Two ISDN BRI, S point circuits (2B+D each).

2-16 Strata CTX I&M 06/04