Toshiba CTX28 manual To Install ACTU1A, Actu PCB CTX100 Processor

Strata CTX100-S/CTX100 Installation

Installing the CTX100 Cabinet

To Install ACTU1A

Refer to Figure 3-18with the following steps.

1.On the ACTU PCB, set the battery jumper, “BATT,” to the “On” position.

2.On the ACTU, make sure the Mu/A jumper plug is set to the Mu position (U.S. and Canada).

3.On the ACTU PCB, set the BBMS jumper “ATTACHED BBMS,” to the “NO” position.

Note If you are installing the AETS option PCB, before mounting the AETS, dress its green jumper wire under and behind the Ethernet port and out the top as shown in Figure 3-18. Remove the screw just above the AETS, place the jumper wire ring over the hole and replace the screw to hold the jumper wire ring in place.

4.Install needed option PCBs onto the ACTU (AETS, AMDS, BSIS, ARCS).

5.Place option PCB arrow side up over the plastic stand-offs with the connectors and stand-off holes on the ACTU. Snap option PCB securely into place.

6.Insert the SmartMedia card (gold contacts face left, notched corner faces forward and up) into the SmartMedia slot on the ACTU.

7.Make sure the power supply switch is Off.

8.Install the ACTU into the Base Cabinet (see following photos).

Note For more details about the jumpers and add-ons (subassemblies) for the ACTU, see Table 3-2 on page 3-22.

		MU/A Law Jumper
SmartMedia Slot
		Mu	A	ACTU1A
SmartMedia Card
				P101
				P301
				NO	YES
Ground				ATTACHED P302
AETS Green Jumper Wire
		AETS1A		BBMS
(10 Base-T Ethernet)				AMDS1A
UP				UP
AETS1A
			BSIS
BSIS1A
(RS232-C, SMDR and SMDI)
		UP				ON
					P601	BACK UP
Control Relay Terminal						OFF
(Night Transfer, etc.)
				ARCS1A
	MOH2	600/600
Future MOH2 Jack		600/600		UP
MOH/BGM1 RCA Jack				P801
MOH/BGM Volume Control	MOH1	600/600
600 ohm page output

Not Used

Not Used

Battery

Backup

Jumper

ARCS1A

(DTMF/ABR Circuits)

5897

Figure 3-18 ACTU PCB (CTX100 Processor)

3-20 Strata CTX I&M 06/04