IP Telephony and QSIG Over IP

Pre-installation Guidelines

Step 3: Install IP Telephones

Before installing any telephone wiring, read the following warning and caution notes:

WARNING!

Never install the telephone wiring during a lightning storm.

Never install the telephone jacks in wet locations, unless the jack is specifically designed for wet locations.

Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

Use caution when installing or modifying telephone lines.

If telephone wiring exits the building, external secondary protection is required. See Chapter 10

– MDF PCB Wiring.

CAUTION! When installing the station cable, do not run the cables parallel if they are within three feet of an AC power line. AC power lines should be crossed at right (90°) angles only. In particular, avoid running station wire pairs near devices that generate electrical noise, such as neon or fluorescent light fixtures.

CAUTION! Do not use cleansers that contain benzene, paint thinner, alcohol or other solvents on the telephone's rubber feet. The color of the rubber may transfer to the desk or mounting surface.

1.Install the AC power adapter onto the IP telephone (IPT).

If using Power over LAN, install PowerDsine unit per the installation manual supplied with that unit.

The IPT1020-SD must use the AC adapter that is provided with the telephone.

Important! To power your Toshiba IPT1020-SD base unit, use only UL

Listed AC Adapter6742 Model BADP120-1A

(supplied with IPT) Ratings are:

Input: 120VAC 60Hz, 250mA

Output: 12VDC 1A

9-8

Strata CTX I&M 06/04

Page 338
Image 338
Toshiba CTX28 manual Install IP Telephones