Toshiba CTX28 manual Attach and Route PCB Cables, Bsis, SMDR, Smdi, Abcs, APSU112A

Strata CTX100-S/CTX100 Installation

Installing the CTX100 Cabinet

Table 3-2 CTX100 Cabinet and Processor Components (continued)

PCB	Provides	Comments	Installs On
AETS	Ethernet LAN (10 BaseT)	One per system. Provides 10Mbps	ACTU1 only
(Optional)		LAN by one RJ45 for WinAdmin.
AMDS		One per system to provide
	V.34 Modem	33.6kbps maximum modem for	ACTU
(Optional)
		WinAdmin.
BSIS	Serial interface unit (same unit used for	Provides four RS-232 serial ports	ACTU
(Optional)	CTX670).	(SMDR, SMDI)
ABCS		One per Power Supply for
	Battery Charger Circuit.	connection of Reserve Power	APSU112A
(Optional)
		(requires ABTC-3M Battery Cable).

Step 19: Attach and Route PCB Cables

1.Determine the direction that you want the cables to exit the cabinet(s) from the following:

•Single Direction Cable Routing – Cabling from the Expansion Cabinet can run through the Base Cabinet and exit from the Base Cabinet (see Figure 3-20).

Power Supply Power Supply

AC Cord and

Battery Cables

CTX100 Installation Strata CTX100-S/

6006

Figure 3-20 Single Direction Cable Routing

•Opposite Direction Cable Routing – Cabling from the Expansion Cabinet can run through the right and left sides (see Figure 3-21).

Power Supply Power Supply

AC Cord and

Battery Cables

6007

Figure 3-21 Opposite Direction Cable Routing

Strata CTX I&M 06/04 3-23