Strata CTX670 Installation

Install Reserve Power

15.Secure the Base Cabinet to the floor using flat washers, lock washer, and hex nuts on each threaded rod.Mount Cabinets to Computer Room Floor (Unbolted).

16.Make sure that cabinet power supplies (BPSU672A) are installed per “Install Power Supply” on page 4-6.

17.Remove front, side, and top covers from all cabinets (Figure 4-5).

Note As shown in Figure 4-5, the two screws on each side cover and the three screws on the front cover (the bottom left screw must be completely removed) should only be loosened and the covers slid to the right for removal.

18.Remove plastic locating parts from all cabinet back covers using a Phillips screwdriver (Figure 4-4).

19.Install a floor fixture (BFIF) on each side of the bottom cabinet (Figures 4-19and 4-23), making sure that the fixture is inside of the cabinet edge.

20.Secure a wall bracket (RWBF) to both floor fixtures with the screws provided. Secure the wall brackets to the wall with customer-provided wood screws and wall anchors.

21.Place a cabinet on top of the bottom cabinet and connect the cabinets together at points “A” and “B”17 with the screws provided.

22.Install wall brackets (RWBF) on the top of cabinet three and secure them to the wall with customer-provided wood screws and wall anchors.

23.Add remaining cabinets, making sure that the cabinets are connected together at points A and B with screws provided.

24.For systems with four or more cabinets, make sure that wall brackets (RWBF) are installed on both sides of the top cabinet, in addition to cabinet three.

25.Connect the data cable of each Expansion Cabinet to the applicable data cable connector on the Base Cabinet (Figures 4-9and 4-12). The data cable from the first Expansion Cabinet should be connected to the connector labeled “CAB. 2”, the cable from the second Expansion Cabinet to the “CAB. 3” connector, etc.).

26.Install ground wiring, AC and reserve power cabling, and PCB cabling per the “Recommended Installation Sequence” on page 4-6.

27.Fill out cabinet/slot identification labels on each cabinet (see Figure 4-8), then reinstall covers on the cabinets. (The top cover should be installed on the top cabinet.)

4-38

Strata CTX I&M 06/04

Page 164
Image 164
Toshiba CTX28 manual Strata CTX670 Installation